musk4
3
Nachrichten |
Eingestellt von 14.10.2009 an 13:51:25
|
|
Portugal
|
Hi everyone
I'm having an issue with the sliders position in my Hercules RMX, both with Traktor 3 and Virtual Dj.
The pitch, crossfader and volume sliders have a little difference in the hardware compared with the position in the software. For example i push the crossfader to the right channel, but leave a little bit space from the end, and in VDJ or Traktor i'ts already at the end.
At mid position, it seems fine with all the sliders.
Is it normal to exist a slight variation compared with the software or is it precisely exact?
Thanks
|
musk4
3
Nachrichten |
Eingestellt von 14.10.2009 an 16:31:31
|
|
Portugal
|
help anyone?
|
lasic
76
Nachrichten |
Eingestellt von 14.10.2009 an 16:36:03
|
|
France
 DJ Console 4-Mx DJ Console Rmx DJ 4Set DJ Control AIR DJ Console Mk4 DJ Control Mp3 e2 DJ Control Steel Deejay Trim 4&6 Deejay Trim 4&6 Scratch starter kit DJ Console MK2 DJ Control MP3 Mobile DJ MP3 VirtualDJ®- Traktor®
- Djuced®
|
Hello musk4,
Yes it seems normal to me. In fact, on the sliders (and the potentiometers too) you have what we called a "dead zone" at the beginning and at the end of the electromechanical components. It means that inside this dead zone you can move the slider or turn the potentiometer but no value is sent.
To check that your Rmx is ok and you can read this topic
http://ts.hercules.com/faqs/eng/her_eng_00353.pdf
|
DJSTEVEZ
30
Nachrichten |
Eingestellt von 16.10.2009 an 05:04:51
|
|
USA
- DJ Console Rmx
- VirtualDJ®
|
I had a similar issue, what i was doing on the RMX with knobs & sliders wasn't occuring on the screen in real time. The solution was reducing the size of the VDJ screen on my Lappy. Good Luck! -Z-
DJ Steve -Z-
DJ Music In Motion www.GotDancing.com
www.RadioRecovery.com
Broadcasting Recovery's Message of Hope
|
Total registrierte Benutzer : 6920 • Neuster registrierter Benutzer : Lucky Dave 
QUOTE
SPRACHE 
RSS FEED